DIY Hardware Accessories

In my older posts I mentioned how I sometimes find inspiration for my projects during trips to the hardware store. One of the upshots of these visits is a "tingga" choker that I created for Yahoo She!

Take a quick visit to your local hardware store and purchase a couple of pieces of washers or “tingga”. These disk-like thingies are generally used to support or fasten screws but is also used to play “sipa” if covered with  cloth or strips of plastic bags. 

Believe it or not, you could also use them to quickly create a fashionable accessory! Washers come in different sizes so feel free to experiment with different designs. 

For this specific piece use five washers in 3 sizes (1 large, 2 medium and 2 small). Keep the  smallest sized washers on each end, with the largest at the center. If you don’t like your choker to appear too shiny you may distress the washers by beating it with a hammer or by scratching the surface with sandpaper. Off set or balance the edgy hardware with a dainty and brightly colored ribbon. 

Materials needed:

Washers

Ribbon, about 1 meter

Procedure:

Step 1: Pass one end of ribbon through the under side of the 1^st washer.  

Step 2: Next slip ribbon through the 2^nd washer. This time pass it from the front towards the back 

Step 3: Flip 2^nd washer over and pass ribbon back through the 1^st washer 

Step 4: Insert ribbon into the 2^nd washer, from the back towards the front 

Step 5: Repeat steps 1-5 until you have threaded the 5^thwasher

Step 6: Tie both ends of the ribbon